Freestanding Baths – Considerations In choosing and Fitting a Waste Kit

Plug and Chain, Click Clack or Pop-up Waste
There are three basic kinds of waste kit. The standard plug and chain waste known to everyone. A retainer plug and chain waste is one in which the plug fits into the overflow grill it uses very little to help keep it of the way. Plug and chain wastes usually come with sometimes a ball chain or even a link chain. Most plug and chain wastes will fit most freestanding baths. A click clack waste is one having a sprung plug which operates like many contemporary basin wastes, you push the connect and it clicks shut, push it again to click it open, with click clack wastes a chrome cover fits over the overflow hole but stands slightly proud of it so as to not block it. A pop up waste is one that’s controlled with a chrome dial that matches over the overflow, a cable works on the outside the bath from your dial to the plug and turning the dial causes the cable to move and operate the plug. Most click clack and pop up waste purchased from major chains will not fit most traditional freestanding roll top baths.

Concealed or Exposed Waste Kit
A low profile waste kit is one which is assumed to become built in circumstances where the few parts which are fitted inside bath is going to be seen, so that all of the pipe work on the outside of the bath – the overflow pipe, trap and outlet pipe might be plastic. An exposed waste kit is all metal/chrome without having plastic parts and is also all built to be seen. A regular double ended freestanding bath if placed about against a wall might be fitted having a concealed waste kit as the pipework is going to be hidden between the bath along with the wall. A single ended traditional freestanding bath will often supply the pipework visible when viewed in profile wherever you put in it so because of these as well as double ended baths which are outside the wall you’ll most likely fit an exposed waste kit having a chrome trap and outlet pipe.

Thickness of Freestanding Baths
Most traditional Freestanding Baths less difficult thicker than standard panel baths and this might cause an issue with many waste kits. All waste kits have a very parts that take a seat on both sides in the plug and overflow holes and repair together to create a sandwich structure with the wall in the bath to be the sandwich filling and elements of the waste kit on both sides. For plug and chain wastes the parts in the waste kits generally connect to a threaded bolt to be able long since the bolts are for a specified duration (that they can are often) then these kits will fit on any thickness of overflow or plug hole. However most click clack and pop up wastes use instead of a bolt a wide bore plastic threaded tube which may be only 7 to 12 mm thick, this isn’t hick enough for many traditional roll top baths.

Fitting a Trap with a Freestanding Bath
Freestanding baths either with or without feet frequently have reduced clearance under the bath along with a standard size bath trap might not fit between the bath along with the floor. If you are able to go into a floor under the bath a hole can be produced inside the floor to the trap to fit into, you can definitely your floor is concrete or of for aesthetic reasons you simply can’t type in the floor then you’ll have to have a shallow or ultra shallow bath trap you could possibly need to get from a specialist.
For details about Freestanding Baths go to our new site: click for more info